PATCH KIT

Mix: 4 Part Sand, 1 Part White Masonry Mix or White Portland

Moisten with 1/2 water and 1/2 Weathermaster (a concrete fortifier)

1) Thoroughly wet area to be patched with water

2) While wet, apply patch. Keep area wet for a day, if possible.

3) When dry, clean with muriatic acid.
Follow instructions for cleaning cast stone

4) When dry, dab on stain to match


Review the installation video we sent you paying particular attention to the section on repairs. You will need to provide either white Portland cement or white sandless grout mix from your local home improvement store. When mixing the sand, weathermaster and water, mix only enough for the repair. (It might be possible to mix it the palm of your hand.) Make the mix about the consistency of cookie dough, not runny. Make sure stone area to be patched is thoroughly wet when you apply the mix. Smooth and pack repair with spatula or trowel. Wipe away any excess patch material from stone immediately with damp rag. Allow to dry for two days, misting the patch 3-4 times lightly on the first day. If patched area appears lighter than the adjacent stone when thoroughly dry, apply a small amount of stain to patch with sponge applicator or Q-tip and wipe away immediately. Repeat this process until area matches the stone.